Web forum is in read-only mode. Login as active registered customer for write access
  Forum Search   New Posts New Posts

Kanban Board Demo

 Post Reply Post Reply
Author
Sanderson Howard View Drop Down
New Member
New Member
Avatar

Joined: 13 Sep 2011
Posts: 10
Post Options Post Options   Quote Sanderson Howard Quote  Post ReplyReply Direct Link To This Post Topic: Kanban Board Demo
    Posted: 10 Jan 2019 at 7:47pm
I have compiled and run the Web Core Kanban Board Demo. It looks OK on the screen but does nothing much.

When I open UDemo.pas in Delphi 10.2 I see two tabs at the bottom of the Unit1.pas page: Code and History. There is no tab for Design. 

If I build a new web project and add a TMSFNCKanbanBoard to the form, I now see at the bottom of the Unit1.pas page four tabs: Unit1.pas, Unit1.html, Design, and History. 

1. Why does the demo not display a Design tab? 

2. If I close and the reopen the new web project Unit1.pas, then the Unit1.html no longer shows up at bottom of the Unit1.pas page. Any idea why this is happening?
Back to Top
Bruno Fierens View Drop Down
TMS Support
TMS Support
Avatar

Joined: 11 May 2010
Posts: 8587
Post Options Post Options   Quote Bruno Fierens Quote  Post ReplyReply Direct Link To This Post Posted: 10 Jan 2019 at 9:50pm
This is because it has been written as one code-base for a VCL, FMX, LCL and Web based application. The conditional defines make the IDE not interpret the form used for the designer.
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down